[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. â· Never allow children or people unfamiliar with the instructions to use the lawnmower. â· Never mow while people, especially children, or pets are nearby. â· Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. [. . . ] With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. The accelerator control regulates the motor speed and also the speed of the blades. There are four different positions for this lever: N = Neutral (no drive) S = Slow F = Fast R = Reverse The lever can be moved steplessly between S and F to ensure the required speed. Quick lifting/lowering of the cutting unit Pull the lever backwards to quickly lift the cutting unit when passing over irregularities in the lawn, etc. During transportation the cutting unit shall be in the highest position. There are four different positions for the ignition key: OFF All electric current broken. Reverse Operation System (ROS) - Allows operation of mower deck or other powered attachment while in reverse (See section 5 - "Driving"). Never leave the key in the ignition lock when leaving the machine on its own. To release the parking brake all that is necessary is to push down the brake pedal. To tow or move the tractor without the aid of the engine, the free-wheel control knob must be pulled out and locked in position. The wheel is easier to turn if the lever for lifting/lowering of the cutting unit is pulled backwards at the same time. Do not smoke when filling with petrol or fill up when the engine is warm. The combined oil refilling cap and the oil stick is accessible when the bonnet is lifted forwards. If more oil is needed add SAE 30 oil to the "FULL " marking. SAE 5W-30 oil should be used during the winter (below freezing point). Make sure that the cutting unit is in the transport position (top position) and that the lever for connection/disconnection of the cutting unit is in the disconnection position. Backing up with the attachment clutch engaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. With engine running, turn ignition key counterclockwise to ROS "ON" position. When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position. Clear the lawn from stones and other objects which can be thrown away by the blades. Begin with a high cutting height and reduce until the required cutting result is obtained. [. . . ] In the direction of travel Check that the air pressure is correct in all four tires. To achieve best cutting results the cutting unit's front edge (B) should be about 10 mm (0. When the correct distance (A) is obtained this setting is locked with the nut (1). At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. [. . . ]